Audio Lab of Georgia

TIRE IT2

.60mH COIL AIR CORE 18 awg wire red Rdc 0.38 ohm 43mm od x 26mm id x 18mm h upc 848791003370 LW18-60 18 gauge perfect layer wound air core inductors are an excellent choice for high quality crossover construction. Features fully annealed refined copper wire, baked enamel insulator, and perfect layer construction. The thin enameled wire permits the tightest windings to minimize DCR and air core construction to ensure no hysteresis and saturation distortions.

10K dual with 7 pins for Onyx 2480

Mackie 0023848 Amp PCB for HR624MKII Last one (NLA from Loud)

AC 120V HA48N7476-5R Output: 18.5V x 2 250mA AC Adapter For Mackie 402VLZ4 4-Channel 402-VLZ3 Premium Mic / Line Mixer 802VLZ4 8-Channel Ultra-Compact Analog Mixer HA48N7476-5R HA48N74765R Input: 120V 60Hz 18W Power Supply Cord Cable

PRO 12 00497070 Impedance: 8 Ohms Power capacity: 800 W Peak 400 W Program 200 W Continuous Sensitivity: 94.3 dB / 1 W 1 m Usable freq. range: 50 Hz ~ 4 kHz Cone: Kevlar® impregnated cellulose Voice coil diameter: 2.375" / 60.3 mm Voice coil material: 2 layers, thermally bonded copper wire Kapton former Nomex® stiffener Net weight lb. / kg: 9.7 lbs. / 4.4 kg Znom (ohms) 8 Revc (ohms) 6.00 Sd (Square Meters) 0.053 BL (T/M) 12.36 Fo (Hz) 48.4 Vas (liters) 86.4 Cms (uM/N) 219.7 Mms (gm) 49.10 Qms 3.84 Qes 0.588 Qts 0.510 Xmax (mm) 2.5 Le (mH) 0.72 SPL (1W 1m) 94.3 No (%) 1.73% Vd (cu. in. / ml) 16.2 / 266 Pmax (Watts pgm.) 400 Disp (cu. in. / ml) 73 / 1192 12" Packed Weight: 12.13 lb (5.5 kg) Packed Length: 14" (35.56 cm) Packed Width: 13.125" (33.34 cm) Packed Height: 6.75" (17.14 cm)

USE 483513037166

006124780001 SAA 1061 478-1 SAA1061 483520987302 48222098082

NAP

NO LONGER AVAILABLE Pot for Spider III Series B10K

This pot is used on the following products: AxSys 212 AX2 POD POD Pro Bass POD Bass POD Pro POD 2.0 all POD XT products POD X3 POD HD POD HD Pro Vetta I & II Duoverb Flextone I II and III and HD147. THIS POT IS NOT TO BE USED TO REPLACE MASTER VOLUME OR OUTPUT POTS on the follow products POD POD 2 POD XT POD XT Pro all Bass POD products all Spider series amps and all Spider Valve series amps. Line 6 recommends these parts be installed by an authorized Line 6 service center. Line 6 assumes no responsibility for any damages done to your amp while installing this part. All sales are final no refunds or exchanges. 01-48-0103 B103

NLA

---

Mono Pot for POD X3 Live 10k LINEAR TAPER 30MM D SHAFT NLA FROM YGG

25k antilog (reverse taper) D shaft ALPHA

10K linear pot

10KB POTENTIOMETER 16mm D shaft L=25mm D=6mm total length=35mm back to tip POT MONO 10KB LINEAR TAPER 25MM D-SHAFT